The DSP-6LP vehicle detector is designed for solar powered gate applications.
The DSP-6LP vehicle detector is “fail-secure” and should be used on free exit loops.
3D Model
LED Indicators: Separate Power and Detect LED’s. The green Power LED blinks once per second to indicate the detector is operating and powered. The red Detect LED will turn on when a vehicle is over the loop detection area.
Sensitivity: Automatically compensates for loops lead-in sizes.
Power: This detector is powered with 10 to 30 VDC or 10 to 28 VAC, approximately 1 mA when not in detect. The relay contacts are rated at 1 amp maximum.
Connector: Removable 7-pin terminal block.
Pin assignments shown below (from left to right).
1: Relay Normally Closed (NC) – contact opens for detect
2: Relay Common
3: Relay Normally Open (NO) – contact closes for detect
4: Power common
5: Power in (10 to 30 VDC or 10 to 28 VAC)
6: Loop
7: Loop
Size: Height: 1.52” Width: 2.9” Depth: 1.56”
Operating Temperature: 35°F to 165°F (-37°C to 74°C)
This ultra low powered vehicle detector is perfect for solar powered applications!
